1. Disconnect the old cable: Locate the end of the cable that is connected to the control lever or engine. Using pliers, loosen and disconnect any retaining clips or fasteners holding the cable in place. If necessary, remove any screws or bolts securing the cable to the engine or control lever.
2. Remove the cable from the mower: Once the cable is disconnected, carefully remove it from any cable guides or routing channels on the mower. Pay attention to how the cable is routed, as you’ll need to replicate this when installing the new cable.
3. Install the new cable: Take the new cable and route it through the same guides and channels as the old cable. Ensure that it follows the same path and aligns with any connection points, such as the control lever or engine.
4. Connect the cable: Attach the end of the new cable to the control lever or engine in the same manner as the old cable. Use pliers to secure any retaining clips or fasteners, and tighten any screws or bolts that hold the cable in place. Double-check that the connection is secure and the cable is properly seated.
5. Adjust the cable tension: Depending on the type of cable, you may need to adjust its tension. Refer to your mower’s manual for specific instructions on adjusting throttle or safety cables. Typically, this involves adjusting the length of the cable using an adjustable nut or other mechanism to ensure proper functionality.

“Keyword”
“how to fix broken self propelled lawn mower cable”
“craftsman lawn mower drive control cable”